Videos - The Coin Bot

Jump to This Time	Transcription Text
00:00:00	so let's give it a test so we can see that the coin sorder stopped in this position between this one bearing and the coin Studio once I rotate it out of the home position we can run the script again and see if the coin order stops in
00:00:14	the same position if it does I think we can call this a success so again it stopped in exactly the same position which is exactly what we wanted it to do it stopped right between that bearing and the coin Studio I've tested this now
00:00:28	several times on the bench without filming it and it stopped in exactly the same position every time the home position for the coin sorder is going to be directly over that little drawer that I built to hold the majority of coins
00:00:40	that have little to no value but as I look down into the coin bot I can see that the coin sorder is not perfectly aligned with that hole but for now I can adjust that in the software and once it homes I can just jog It Forward just a
00:00:45	little bit to make sure that it's perfectly aligned