| Jump to This Time | Transcription Text |
|---|---|
| 00:00:00 | and the mosy pin is that you can see solder in here is actually connected to the data pin on the voltage lifter the output of that is connected to the back of this resistor and that flows all the way out to the addressable LED strip uh |
| 00:00:15 | data line on this yellow wire here I also check the power rail that is supposed to be connected to this last pin here on the voltage lifter but and this wire here this red wire is supposed to be plus 5 volts I get plus five on |
| 00:00:31 | the end of The Wire here but when I tested against between ground and this pin I was getting zero so that led me to believe when I flipped the board over I could see that I had actually forgotten to solder these two together and that |
| 00:00:39 | was the main power issue for the addressable LEDs they were not getting plus five volts |
Automated Coin Roll Hunting