Videos - The Coin Bot

Jump to This Time	Transcription Text
00:00:00	so I began by recreating the coin slider with slightly longer coin Grabbers but as you can see I pushed these out to the edge a little bit more so that they were closer to this lip here and when I put these in
00:00:16	position these are very tight tolerances so they really just snap together and once you do that they're flush like I said they're very it's a tight fit there once you do that these are flush here and they stick up
00:00:37	pretty significantly from the top here I'm very proud of the way that this came out because I created a little recess here for this coin slider to slide up and down in I made sure that there was no interference between this gear and
00:00:45	the the compliant mechanism that we talked about in the last episode and also these posts will fit into these holes here on the ring